Service manual

G424F(FE) Service Manual Chapter 3. Engine Mechanical System 57
Camshaft Case Cover and
Gasket
Removal
Remove or disconnect
1. Spark plug cables from the support.
2. Breather hose from the valve cover.
3. Camshaft case cover attaching bolts, with a 10-
mm socket wrench and handle.
4. Camshaft case cover and gasket.
Installation
Install or connect
1. A new gasket and camshaft case cover.
2. Camshaft cover attaching bolts, without tightening.
Obs.: Install the spark plug cables together with the
bolts.
3. With a 10-mm socket wrench, extension and
torque wrench; tighten.
Tighten
• Bolts: 4 – 10 N·m (3 – 7 lb·ft.).
4. Breather hoses in the camshaft case cover.
5. Spark plug cables on the supports.
Crankshaft Accessory Pulley
Removal
Remove or disconnect
1. V pulley belt; see “V Pulley Belt – Removal”, in
this section.
2. Crankshaft accessory pulley attaching bolt, with a
13-mm socket wrench and handle.
3. Crankshaft pulley.
4. TDC sensor and CAS sensor.
Installation
Install or connect
1. Accessory pulley with attaching bolts, without
tightening.
2. With a 13-mm socket wrench and torque wrench;
tighten the pulley attaching bolts.
Tighten
• Bolts: 15 – 25 N·m (11 – 18 lb·ft.).
3. V pulley belt; see “V Pulley Belt – Installation”, in
this section.