Service manual

G424F(FE) Service Manual Chapter 3. Engine Mechanical System 72
Oil Pump
Removal
Remove or disconnect
1. Timing pulley rear cover; see “Timing Pulley Rear
Cover – Removal”, in this section.
2. Crankshaft timing pulley, use a 17-mm socket
wrench and handle to remove the attaching bolt.
3. Oil filter.
4. Position the vehicle on an elevator and raise it.
5. Engine oil pan; see “Oil Pan – Removal”, in this
Section.
6. Oil screen, with a 10-mm socket wrench and
handle, to remove the oil screen-to-oil pump bolt
and a Torx 13-mm wrench and handle to remove
the oil screen-to- framing grille bolt.
7. Oil pressure sensor electric connection.
8. Timing belt Tensioner attaching bolt, with a 13-
mm combination wrench and remove the
Tensioner.
9. Oil pump attaching bolt, with a 5-mm Allen
wrench.
10. Oil pump.
Installation
Install or connect
1. Oil pump new gasket to the cylinder block.
2. Oil pump to the cylinder block and attaching bolts,
without tightening.
3. With a 5-mm Allen wrench and torque wrench,
tighten the oil pump attaching bolts.
Tighten
• Bolts: 6 – 10 N·m (4.4 – 7 lb·ft.).
4. Oil screen to the oil pump and attaching bolts,
without tightening.
5. Oil screen-to-framing grille attaching bolt, without
tightening.
6. With a Torx E12 wrench and torque wrench,
tighten the oil screen-to-framing grille attaching
bolt.
Tighten
• Bolt: 4 – 10 N·m (3 – 7 lb·ft.).
7. With a 10-mm socket wrench and torque wrench,
tighten the oil screen-to-oil pump attaching bolts.
Tighten
• Bolts: 6 – 12 N·m (4.4 – 8.8 lb·ft.).
8. Oil filter.
9. Oil pan; see “Oil Pan – Installation”, in this section.
10. Oil pressure sensor electric connection.
11. Timing belt automatic Tensioner and attaching
bolt, without tightening.