Item Brochure

PO BOX 151 v WEBB CITY, MO 64870 v PH [phone] v FAX [phone]
www.detectoscale.com
Technical Support: PH [phone]
v [e-mail]
IMPORTANT!
Please read through instructions carefully before starting to assemble. Remove all
parts and hardware from carton. Only finger-tighten bolts and nuts until entire
assembly is completed.
ASSEMBLY
1. Remove all packing material and contents of the carton.
2. Peel the protective plastic back on each item far enough to expose the bolt holes. In order
to protect the finish of the table, it is recommended to leave the remainder of the protective
plastic on, until the table is completely assembled.
3. Referring to the Side View, place two LEG ASSEMBLY
e on a flat level surface, such as
a table or bench.
4. Next place SHELF
d on the inside of LEG ASSEMBLY e and position at the desired
height (one of the three holes).
5. Align hole in SHELF
d with hole in one LEG ASSEMBLY e. With bolt head on outside
and nut on inside, insert CARRIAGE HEAD BOLT
g through side holes and secure with
1/4-20 S.S. ACORN NUT h. Finger-tighten only! Repeat for other LEG ASSEMBLY e.
6. Now place TABLE TOP
c on the inside of LEG ASSEMBLY e.
7. Align hole in TABLE TOP
c with hole in one LEG ASSEMBLY e. With bolt head on
outside and nut on inside, insert CARRIAGE HEAD BOLT g through side holes and
secure with 1/4-20 S.S. ACORN NUT h. Finger-tighten only! Repeat for other LEG
ASSEMBLY
e.
8. Place remaining two LEG ASSEMBLY
e on each end of SHELF d and TABLE TOP c.
9. Align hole in SHELF
d with hole in one LEG ASSEMBLY e. With bolt head on outside
and nut on inside, insert CARRIAGE HEAD BOLT g through side holes and secure with
1/4-20 S.S. ACORN NUT
h. Finger-tighten only! Repeat for other LEG ASSEMBLY e.
10. Align hole in TABLE TOP
c with hole in one LEG ASSEMBLY e. With bolt head on
outside and nut on inside, insert CARRIAGE HEAD BOLT
g through side holes and
secure with 1/4-20 S.S. ACORN NUT h. Finger-tighten only! Repeat for other LEG
ASSEMBLY e.
11. Referring to the End View, rotate the table on its end.
12. With bolt head on outside and nut on inside, insert CARRIAGE HEAD BOLT
g through
the four remaining holes in SHELF d and secure with 1/4-20 S.S. ACORN NUT h.
Finger-tighten only!
13. With bolt head on outside and nut on inside, insert CARRIAGE HEAD BOLT
g through
the four remaining holes in TABLE TOP
c and secure with 1/4-20 S.S. ACORN NUT h.
Finger-tighten only!
14. Using the 7/16" wrench, tighten each 1/4-20 S.S. ACORN NUT
h securely.
15. Remove the remainder of the protective plastic on the table before using.