User's Manual
Table Of Contents
- 1 About this manual
- 2 Grouped safety messages
- 3 Product description
- 4 Design and Function
- 5 Installation
- 6 Start-up
- 6.1.1 Service switch
- 6.1.2 Cold start
- 6.1.3 Starting the service mode
- 6.1.4 Starting the service mode and setting the service IP address
- 6.1.5 Starting the terminal software / warm start
- 6.2.1 Communication
- 6.2.2 Comparing finger templates
- 6.2.3 1-click installation
- 6.2.4 Configuration
- 6.3.1 Start-up procedure
- 6.5.1 Ethernet settings
- 6.5.2 Host interface
- 6.5.3 Reader settings
- 6.1.1 Service switch
- 7 Operation
- 8 Maintenance
- 9 Packaging / returns
- 10 Disposal
- 11 Index
Installation Manual
40 04043988 - 02/2014 B-eco
5.6 Fastening the terminal housing to the mounting plate
Fasten the terminal housing to the mounting plate as follows:
1 Hang terminal housing into the mounting lugs of the mounting plate and
slide it downwards.
2. Secure terminal housing on the mounting plate using locking screw K30x10
TORX.
3. Strain-relieve the installation lines on the mounting plate using cable binders.