User's Manual
Table Of Contents
- 1 About this manual
- 2 Grouped safety messages
- 3 Product description
- 4 Design and Function
- 5 Installation
- 6 Start-up
- 6.1.1 Service switch
- 6.1.2 Cold start
- 6.1.3 Starting the service mode
- 6.1.4 Starting the service mode and setting the service IP address
- 6.1.5 Starting the terminal software / warm start
- 6.2.1 Communication
- 6.2.2 Comparing finger templates
- 6.2.3 1-click installation
- 6.2.4 Configuration
- 6.3.1 Start-up procedure
- 6.5.1 Ethernet settings
- 6.5.2 Host interface
- 6.5.3 Reader settings
- 6.1.1 Service switch
- 7 Operation
- 8 Maintenance
- 9 Packaging / returns
- 10 Disposal
- 11 Index
Manual Installation
B-eco 04043988 - 02/2014 41
5.7 Fastening of devices with additional sealing (IP54 version)
Fasten the terminal housing to the mounting plate as follows:
1. Insert the installation cables through the cable inlets on the bottom of the
sealing and connect them to the device.
1
9
,5
21
1
9
,5
Ø 6,5 (4x)
2. Slide sealing through the terminal housing from behind.
3. Hang terminal housing into the mounting lugs of the mounting plate and
slide it downwards.
4. Secure terminal housing on the mounting plate using locking screw K30x10
TORX.