User's Manual
Table Of Contents
- 1 About this manual
- 2 Grouped safety messages
- 3 Product description
- 4 Design and Function
- 5 Installation
- 6 Start-up
- 6.1.1 Service switch
- 6.1.2 Cold start
- 6.1.3 Starting the service mode
- 6.1.4 Starting the service mode and setting the service IP address
- 6.1.5 Starting the terminal software / warm start
- 6.2.1 Communication
- 6.2.2 Comparing finger templates
- 6.2.3 1-click installation
- 6.2.4 Configuration
- 6.3.1 Start-up procedure
- 6.5.1 Ethernet settings
- 6.5.2 Host interface
- 6.5.3 Reader settings
- 6.1.1 Service switch
- 7 Operation
- 8 Maintenance
- 9 Packaging / returns
- 10 Disposal
- 11 Index
Start-up Manual
46 04043988 - 02/2014 B-eco
6.4 Manual settings
Device settings can also be made manually. This might be required, for example, to
define a fixed network address or to configure later hardware extensions.
There are the following options to adapt the parameters:
• Service mode
For the setting of the parameters via menu-controlled service functions per
HTTP browser, see BECO service module manual.
• Remote setup
Modify the parameters via FTP (see BECO service module manual).
• B-COMM
Modify the parameters via the "Terminal basis settings" menu item (see BECO
service module manual).