User's Manual
Table Of Contents
- 1 About this manual
- 2 Grouped safety messages
- 3 Product description
- 4 Design and Function
- 5 Installation
- 6 Start-up
- 6.1.1 Service switch
- 6.1.2 Cold start
- 6.1.3 Starting the service mode
- 6.1.4 Starting the service mode and setting the service IP address
- 6.1.5 Starting the terminal software / warm start
- 6.2.1 Communication
- 6.2.2 Comparing finger templates
- 6.2.3 1-click installation
- 6.2.4 Configuration
- 6.3.1 Start-up procedure
- 6.5.1 Ethernet settings
- 6.5.2 Host interface
- 6.5.3 Reader settings
- 6.1.1 Service switch
- 7 Operation
- 8 Maintenance
- 9 Packaging / returns
- 10 Disposal
- 11 Index
Manual About this manual
B-eco 04043988 - 02/2014 7
1 About this manual
Validity This manual describes the Kaba B-eco terminal starting from
Manufacturing date: February 2014
Serial number: 079940-000100
Service module version: 697-00-X-K07
B-Client PDC6 version: 766-01-X-K00
767-01-X-K00
This manual describes all device versions and optional equipment and functions.
Options must be purchased and are therefore only available if they were purchased.
Additional equipment and functions may not yet be available at the time of issuing
the manual and can possible only be purchased at a later stage.
Addressees
This manual is written exclusively for specialists.
The descriptions in this manual are intended for personnel trained by the
manufacturer. The information in this manual cannot substitute the product
training.
The contents of this manual is intended for use by the following groups of people:
• Project manager
Project manager who is responsible for the system and entrusted with
project planning and realization.
• Fitter
Person specialized in mounting and installation.
Person who has an adequate technical training and sufficient experience and
who has been authorized by the manufacturer after completing the training
on the product.
• Service technician
Specialist for initial set-up and maintenance of the installation.
Person who has an adequate technical training and sufficient experience and
who has been authorized by the manufacturer after completing the training
on the product.
• Network administrator
Realizes the set-up of the device within the network and makes sure that the
devices are accessible within the network.
• Software partner
Specialists for connecting the system to the user software by defining
operating and booking sequences, programming the customer applications
and setting the parameters of the devices.
Important!
For reasons of device safety, some of the activities might only be carried out by the
SERVICE PERSON.
Only persons of the groups "Fitter" and "Service technician" have the status of a
SERVICE PERSON according to DIN EN 60950-1:2006.