User's Manual
Table Of Contents
- 1 About this manual
- 2 Grouped safety messages
- 3 Product description
- 4 Design and Function
- 5 Installation
- 6 Start-up
- 6.1.1 Service switch
- 6.1.2 Cold start
- 6.1.3 Starting the service mode
- 6.1.4 Starting the service mode and setting the service IP address
- 6.1.5 Starting the terminal software / warm start
- 6.2.1 Communication
- 6.2.2 Comparing finger templates
- 6.2.3 1-click installation
- 6.2.4 Configuration
- 6.3.1 Start-up procedure
- 6.5.1 Ethernet settings
- 6.5.2 Host interface
- 6.5.3 Reader settings
- 6.1.1 Service switch
- 7 Operation
- 8 Maintenance
- 9 Packaging / returns
- 10 Disposal
- 11 Index
Operation Manual
54 04043988 - 02/2014 B-eco
7.5 Operating sequences
The terminal functions and operating sequences depend on the set parameters.
Parameter setting allows extensive adaptation to a wide range of applications.
The following examples refer to the B-Client PDC6 terminal software in its default
setting.
7.5.1 Basic state
We 01.08.2012 15:35:52
Select function
Time Order CC
F1: IN
F2: OUT
F3: Official absence
F4: Query
F5:
In its basic state, the display shows tabs. A tab is selected by pressing special keys S1
to S3. The tab contains the currently correct assignment of the function keys.
Special key S4 is used to select the language.
7.5.2 Active function
We 01.08.2012 15:36:27
IN
Present badge
F1: IN
F2: OUT
F3: Official absence
F4: Query
F5:
After selecting a function, you are asked for the first input step, for example "Present
badge".
The valid assignment of the function keys for the current tab is still displayed even
when the function has been activated. A different function can still be selected.