User's Manual

1. Click the icon of ReadCard application program to enter into the application program interface.

2. Click “setup” button and the following interface will be popped out:



3. Click device and select "ttys2 (serial) ".

If the device installs ID card module, select "9600” for "Baud rate" and select "ID" for "card_type";

If the device installs MF card module, select "115200" for "Baud rate" and select "MF" for

"card_type";

If the device installs LEGIC card module, select "115200" for "Baud rate" and select "LEGIC" for

"card_type";

Press the return button after setting to go back to application program interface.

4. Click "Enter" button, enter into card swiping interface and swipe the card. Press “quit” button to quit.


2.3 ． Operation introduction to GPIO Demo

1. Click the icon of GPIO Demo application program to enter into the application program interface.
‐ 3 ‐
