User's Manual

Table Of Contents
Description of the Subpartyline Manual B-Net® 91 04
46 © Kaba GmbH 12/2008
8.7 Escape sequences
The subterminal functions are controlled by the following escape sequences.
Which ESC sequences are used or supported depends on the particular control
unit.
8.7.1 Controlling LED, relay and beeper
With the following sequences, the relay and the acoustic signal transmitter
(beeper) in the subterminal are controlled.
Meaning Code
Switching on LED n
<ESC>[Pnq
Switching on flashing LED n
<ESC>[?Pnq
Switching off LED n
<ESC>[=Pnq
Pn: Number of the local LED: 1 to 2
Meaning Code
Switch off relays and beeper
<ESC>[ q
Turn on beeper
<ESC>[99q
Switch on beeper alternatingly
<ESC>[?99q
Turn off beeper
<ESC>[=99q
Switch on relay
<ESC>[3q
Switch off relay
<ESC>[=3q
The acoustic signal transmitter in the subterminal is activated by means of the
control character <BEL> for 0.3 seconds. The acoustic signal transmitter does not
have to be switched off afterwards.
Meaning Code
Activate the beeper dynamically
<BEL>
8.7.2 Reset
The following ESC sequence will reset the subterminal. The same settings as after
a warm start apply for all parameters.
Meaning Code
Perform reset
<ESC>c
After a reset, the subterminal will send the ESC sequence “LOG IN”.
Meaning Code
LOG IN
<ESC>[98~