User's Manual
Table Of Contents
- Table of Contents
- 1 About this document
- 2 Basic safety information
- 3 Product description
- 4 Construction and function
- 4.1 Device structure
- 4.2 Product versions
- 4.3 Terminal software
- 4.4 System connection
- 4.5 Authentication types
- 4.6 CardLink
- 5 Installation
- 6 Commissioning
- 7 Operation
- 8 Maintenance
- 9 Packaging/Returns
- 10 Disposal
- Index
InstallationTechnical Manual
4504043552 - 07/2017 Terminal 97 00
5.3 Fastening the docking station
First make the required cut-outs for introducing the installation line(s). Introduce the install-
ation lines from below or from the rear.
Fastening the docking station, dimensions in mm.
The docking station is mounted directly to the wall using screws/dowels. There are three oval
fastening holes(1) in the docking station for fastening.
Fastening material (included in the delivery):
• 3 wood screws Ø 4.5 x 35 (2)
• 3 washers (3)
• 3 dowels 6 mm (4)
The washers (3) cover the fastening hole (1) completely after tightening the screw. The de-
livered washers must also be used if you use other fastening screws (depending on the
mounting surface).
In case of soft mounting surfaces, make sure that the housing is not pressed into the surface
when mounting it.
The unevenness of the mounting surface may not exceed 0.5 mm. The unevenness of the
mounting surface may have to be compensated for or adjusted by means of suitable meas-
ures (e.g. washers).
If the mounting surface is not even, we recommend using the mounting plate (5). It is placed
between the wall and the docking station. The relatively rigid mounting plate avoids mechan-
ical distortion of the docking station.
The mounting plate is available as accessory under the order number 04043450.