User's Manual

Installation Manual
Installation
4 Installation
4.1 Installation conditions
4.1.1 General
An accurate installation of all components is a basic requirement for a properly
functioning device. The following installation instructions must be adhered to.
4.1.2 Installation site
Clearances
Keep a distance of 20 cm on all sides between two devices with RFID readers.
Mounting height
The recommended mounting height is 140 cm to the top edge of the terminal.
Electromagnetic fields
The terminal must not be installed in the area of strong electromagnetic fields
caused by switching power supply, power lines, phase controllers, etc.!
Electromagnetic fields can affect the reading power or cause failures, in particular
with contactless readers (RFID).
Sun exposure
Direct sun exposure leads to reflections within the display area and a poor readability
of the display.
Please avoid installation at places with direct sunlight.
4.2 Connections
All connection cables for the terminal are plugged in at the bottom side of the
terminal.
1
32
4
5
1 Connector for the add-on module
2 RJ45 jack Ethernet 10/100 and PoE (optional)
3 Screw terminal for RS485 and Relay (optional)
4 DC Socket 6.5 mm for Power Supply 12 .. 24 V DC
5 Type-A USB 2.0 Host
16 04044239 - 08/2013 TT1100