User's Manual

_________________________________________________________________________________

16 User Manual Bedas 93 20 12/99

2 Installation

The applicable rules of safety of electrical equipment must be observed

when installing components !

No modifications are allowed to be made by the user ! Otherwise, the

permission to operate the device is void !

Note: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the FCC rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment gene-

rates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions,may cause harmful inter-

ference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the fol-

lowing measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

PAGE 1
_________________________________________________________________________________ 2 Installation The applicable rules of safety of electrical equipment must be observed when installing components ! No modifications are allowed to be made by the user ! Otherwise, the permission to operate the device is void ! Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.
PAGE 2
_________________________________________________________________________________ 2.1 Power Supply Before any device is connected to the supply voltage, it must be checked if the line voltage is corresponding with the devices requirements. See type label of the device. Devices which are dedicated for installation in dry rooms, e.g. offices, are not allowed to be installed outdoors or in rooms where splashing water might occur.
PAGE 3
_________________________________________________________________________________ conformity with directive 89/336/EWG and 93/68/EWG checked according to EN 50081-1 and EN 50082-2 Additionally for terminal with Legic reader: Contains FCC ID: NVIWRU-100 This device complies with Part 15 of the FCC Rules.