User's Guide

dormakaba USA Inc. System User Guide 7040.0320 | 24
3.8.3 Edit User
3.8.3.1 Edit User – Display Keypad
Follow these steps to edit a User on a Display Keypad:
1. Navigate through the Main Menu and select Users.
2. From the sub-menu, select Edit.
3. Input the User ID to be edited.
4. To change the Status of a User, do the following:
a) Select Status
b) Select between Enabled and Disabled
5. To Reset the Combination, do the following:
a) Select Reset Combo
b) New Combo appears on screen. Input a new Combination with the number pad
Note: The new Combination must be different from the old Combination. The User is advised to use a strong
combination.
c) Confirm appears on screen. Input the same Combination from the previous step to confirm. Success combo reset
appears on screen. The Keypad will beep three times and flash a green LED once complete
6. To change User Privileges, do the following:
a) Select Privileges
b) Select from Open Priv, Audit Priv, TDO Pin Priv and Timelock Priv. For each, use the Keypad to select which locks
the User will have privilege(s) on, if applicable
7. To change the User Type, do the following:
a) Select User Type
b) Select between Standard User and Manager
8. Navigate through the options and select Update User. Success appears on screen. The Keypad will beep three times and flash
a green LED once complete.
3.8.3.2 Edit User – Non-Display Keypad
For entries without a display, do one of the following:
a) #54 – Enable/Disable User
• Temporarily suspends user access to the system. For example, if a user is on vacation
b) #55 – Edit User Lock Privileges
• Add or remove privileges for the user to a lock
c) #57 – Reset User Combination
• Allows a Master or Manager user to reset another user’s combination
See Appendix A for the complete format of these # Commands.