User's Guide

dormakaba USA Inc. System User Guide 7040.0320 | 33
3.11 Time Delay
During a Time Delay, the safe lock cannot be opened until the delay period expires. There are multiple ways to override the Time
Delay period, if enabled. If Time Delay is enabled for a lock, each valid User ID with a Combination will trigger the start of the time
delay period if the intent is to open the lock. The Time Delay period ranges from 00 (Disabled) to 99 minutes and can be set either
via the Keypad or through the LA GARD Software client. Once the Time Delay period is complete, the Confirmation Window period
starts that would allow re-authentication to open the lock without needing to wait for the time delay period to expire.
3.11.1 Enable/Disable Time Delay
3.11.1.1 Enable/Disable Time Delay – Display Keypad
Follow these steps to Enable/Disable Time Delay on a Display Keypad:
1. Navigate through the Main Menu and select System.
2. Select Locks from the sub-menu.
3. Select TimeDelay.
a) For multi-lock systems, select the corresponding lock number on the keypad
4. To change the TimeDelay period, do the following:
a) Select ConfigureTimes
b) Select Delay Period
c) Use the keypad to input a new Time Delay (between 00 [Disabled] and 99 minutes)
Note: For a multi-lock setup, repeat Steps 1 through 4 for each safe lock.
d) Success TD Updated appears on screen and the Keypad will beep three times and flash a green LED once complete
5. To change the Confirm Window time (the time frame in which the safe lock can be opened), do the following:
a) Select TimeDelay
i. For multi-lock systems, select the corresponding lock number on the keypad
b) Select ConfigureTimes
c) Select ConfirmWindow
d) Use the keypad to input a new Confirm Window time (between 01 and 60 minutes)
Note: For a multi-lock setup, repeat Steps 5a through 5d for each safe lock.
e) Success TD Updated appears on screen and the Keypad will beep three times and flash a green LED once complete
3.11.1.2 Time Delay Count Mode – Display Keypad
For Entries with a display, there is an option to configure the time display for their respective time delay feature. Select one of the
following options:
1. Off.
2. Count Up.
3. Count Down.