User's Manual

Commissioning Technical Manual
48 04047408 - 10/2020dormakaba access manager 92 00 9200-K7 TP4-Client
6.4 Additional steps for Legic media technology
With Legic media technology, a write/read authorisation is required in the following cases:
• If it is necessary to write to a write-protected segment of a medium.
Example: AoC
• If a read-protected segment of a medium is to be read.
6.4.1 Grant read/write authorisation
The authorisation is granted via a registration unit.
The term “Write authorisation” is used in this chapter for the terms “Write authorisation” and
“Read authorisation”.
A write authorisation with a LEGIC prime SAM 63 card is only valid for LEGIC prime.
A write authorisation with a LEGIC advant SAM 63 card is valid for LEGIC prime and LEGIC
advant 15693 and 14443A.
In this chapter, the names “Security card C2“ are used for the card names “SAM 63” and “Se-
curity card C2 (SC-C2)” .
Requirements
• A security card C2 with the corresponding segment zone is present.
• The ISO standard 14443A must have been activated with the security card C2.
• The ISO standard of the SAM 63 card must conform to the parameterised ISO standard.
• The device is in normal operation and waits for a RFID input.
Procedure
1. Hold the security card C2 in the RFID field until the signalling takes place
ð Signalling after successful write authorisation:
3x beep
glows red till the next booking takes place
ð Signalling after unsuccessful write authorisation:
- “Access not authorised”
Possible reasons
- The security card C2 was removed too early from the RFID field.
- If no reaction: ISO 14443A is not activated in the system
- If using SAM+ media: there are no credits available
2. Remove the security card C2 from the RFID field.
prelimenary