Programming Instructions

DORM45 Programming Instructions
Programming Instructions:
1. Enter vehicle with existing and new keys.
2. Plug programmer into OBD port (located below steering column)
3. Programmer will beep 1 time.
4. With your foot off the brake, press the start/stop button 2 times to the run position.
5. Wait 10 seconds for the program to beep and press start/stop button to OFF position.
6. Wait 20 seconds for programmer to beep 3 times and programmer light to turn green. Once
this has happened you are now in programming mode and ready to program your new remote.
7. Hold the remote to be programmed over the center counsel/center armrest. Press the lock
or unlock button multiple times until the door locks cycle and the hazard lights flash in the
instrument cluster.
8. Remove programmer.
9. Test remotes and make sure they function properly.
10. Repeat the procedure if the process has failed.
FCC WARNING
Statement 15.19(a)(3): This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by Dorman Products Inc. could void the user’s authority to operate the equipment.
FCC Part 15.21: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR
COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
IC WARNING
FVIN 6399450IC
The term IC before the Certification/Registration number only signifies that the Industry Canada technical specifications were met. This device complies
with Industry Canada’s license-exempt RSSs Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.