Programming Instructions

PROGRAMMING ADDITIONAL REMOTES REQUIRE AT LEAST ALREADY

PROGRAMMED REMOTE

Programming Instructions:

Disclaimer: All currently programmed and new remotes must be reprogrammed to

vehicle. Please have all remotes in hand at time of programming.

Once plugging in the programmer you will have 2 minutes to program all new and

existing remotes to vehicle. After 2 minutes your session will time out and your

vehicle will no longer be in programming mode. Programmer will work for no more

than 3 sessions.

1. Close and lock doors.

2. Insert Key into ignition and turn to IGN ON (Do not crank).

3. Insert Programmer into your vehicle’s OBD2 Port. This port is typically

located underneath the dashboard below the steering wheel. It may be

covered by a faceplate that will easily pop off.

4. Once the Programmer is inserted, wait for a chime or orange light on the

Programmer to come on. This will indicate that the unit is ready to

program the first remote.

5. Press and hold the lock and unlock button on the remote simultaneously

until you hear a chime, buzzer, or the door locks cycle (approximately 10-

15 seconds).

6. To program additional remotes, repeat step 4.

7. When all remotes are programmed wait 60 seconds for buzzer to sound

continuously, then remove programmer from OBD2 Port.

FCC WARNING

Statement 15.19(a)(3): This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation. Changes or

modifications not expressly approved by Dorman Products Inc. could void the

user’s authority to operate the equipment.

IC WARNING

FVIN 6399105IC

PAGE 1
PROGRAMMING ADDITIONAL REMOTES REQUIRE AT LEAST ALREADY PROGRAMMED REMOTE Programming Instructions: Disclaimer: All currently programmed and new remotes must be reprogrammed to vehicle. Please have all remotes in hand at time of programming. Once plugging in the programmer you will have 2 minutes to program all new and existing remotes to vehicle. After 2 minutes your session will time out and your vehicle will no longer be in programming mode. Programmer will work for no more than 3 sessions. 1.
PAGE 2
PROGRAMMING ADDITIONAL REMOTES REQUIRE AT LEAST ALREADY PROGRAMMED REMOTE This device contains licence-except transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: 1) This device may not cause interference. 2) This device must accept any interference, inclduing interference that may cause undesired operation of the device.