Installation Manual

REMOVAL/INSTALL INSTRUCTIONS: KEYLESS ENTRY REMOTE
13723
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualied auto technician
before attempting to perform any work you are not qualied to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Trac Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specic service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualied technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
1
©2020 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
REMOVAL/INSTALL OF KEYLESS ENTRY REMOTE (13723)
Cadillac 2010–07, Chevrolet 2010–07, GMC 2010–07
Programming Instructions
Disclaimer: All currently programmed and new remotes must be reprogrammed to
vehicle. Please have in hand at time of programming.
Use this Procedure for Vehicles with Drivers Information Center Buttons
This information is in your Owners Manual in the Drivers Information Center Section
STEP 1: Insert Key and turn to ON position so you can access Drivers Information Center.
STEP 2: Press the vehicles information button until PRESS TO RELEARN REMOTE
KEY displays.
STEP 3: Press the set/reset button until REMOTE KEY LEARNING ACTIVE displays.
STEP 4: Press and hold the lock and unlock buttons on the rst keyless remote at the
same time for approximately 15 seconds. A chime will sound indicating that the remote
is programmed.
STEP 5: To program additional remotes at this time, repeat Step 4. This vehicle can have a
maximum of 8 remotes programmed.
STEP 6: To exit programming mode, turn key o and remove key. Test remote(s).
Use this Procedure for Vehicles without Drivers Information Center Buttons
To access this display, the vehicle must be in Park (P) with key in the on position (as far as
you can go without cranking the engine).
STEP 1: Press the trip odometer reset stem until RELEARN REMOTE KEY displays.
STEP 2: Press and hold the trip odometer reset stem for three seconds. The message
REMOTE KEY LEARNING ACTIVE will display.
STEP 3: Press and hold the lock and unlock buttons on the rst keyless remote at the
same time for approximately 15 seconds. A chime will sound indicating that the remote
is programmed.