Installation Manual

INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR
742-272
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualied auto technician
before attempting to perform any work you are not qualied to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Trac Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specic service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualied technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
1
REMOVAL/INSTALL OF WINDOW REGULATOR (742-272)
Ford Expedition 1997–2002, Lincoln Navigator 1998–2002,
Ford F-150 Super Crew Cab 2001
General Tech Tips:
• Usepainter’staperatherthanducttapetosecurewindow.Itwillnotdamagepaintorleavestickyresidue.
• Aplasticprytoolisuseful.Itwillnoteasilydamagedelicatetrimlikeascrewdriverormetalprybar.
• Thereplacementregulatorshouldhavealiberalamountofgreaseonslidearea.Ifthereisnotmuchgrease
present,whitelithiumgreaseworkswelltolubricatetheslidearea.
• Aftermarketwindowtintingcancausethewindowtotravelslowerandputadditionalstrainonthewindow
regulatorassembly.
• Windowrunchannelsshouldbecleanedandlubricatedbeforeinstallationofanewwindowregulator
assembly.Siliconesprayworkswell.
PLEASE WEAR SAFETY
GLASSES!
Tools required for removal and
installation of window regulator and
motor assembly:
•Siliconespraylubricant
•Trimpanelremovaltool
•Pick
•Saddlecupassembly,tapeorwedge
to hold window in place
•Flat-bladescrewdriverorplasticpry
tool
•10mmsocketordriver
•Phillipsscrewdriver
•Greasepencilormarker
•8mmcombinationwrench
andan11mmsocket
•1/8”drillbit,3/8”reversibledrill,pop
rivet gun