Installation Manual

99377
1
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specic service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualied technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
TECH NOTES: INSTRUCTIONS
©2019 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualied auto technician
before attempting to perform any work you are not qualied to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Trac Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
Ford 2019–11, Lincoln 2015–13
PROGRAMMING INSTRUCTIONS
DISCLAIMER: Programming additional remotes require at least ONE already
programmed remote.
1. Be sure to have all currently programmed remotes available for this process.
Any remotes not present will be erased.
2. Turn the ignition OFF.
3. Plug the programming dongle into the OBD-2 port.
4. Using a valid remote, press lock and then unlock.
5. Wait 5 seconds. The programmer will beep a short beep and the green LED will blink.
6. Wait 20 seconds. The programmer will begin to ash the red LED every second to
indicate security access is in progress.
7. After 10 minutes the programmer will beep and turn on the green LED to indicate
security access has been gained.
8. Press the button to erase all stored key data. This will erase all currently programmed
keys to the vehicle. All previously programmed keys must be relearned during this
process. The programmer will beep a short beep to denote the button press.
9. The programmer will then beep a long beep and turn on the green LED to indicate
that all keys have been erased.
10. Place a remote into the programming socket, then press the button
on the programmer.
11. The programmer will beep a short beep and the LED will remain o to indicate that
the remote has been detected in the socket.
12. The red LED will blink until the remote is programmed.
13. The programmer will beep a long beep and the green LED will turn on to indicate
that the key has been successfully programmed.
14. Remove the programmed remote from the socket. Test the remote by pressing
Lock/Unlock.
15. Place the next remote into the programming socket, then press the button on the
programming dongle.