Installation Manual

99377
2
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specic service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualied technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
TECH NOTES: INSTRUCTIONS
©2019 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualied auto technician
before attempting to perform any work you are not qualied to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Trac Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
16. The programmer will beep a short beep and the LED will remain o to indicate that
the remote has been detected in the socket.
17. The red LED will blink until the remote is programmed.
18. The programmer will beep a long beep and the green LED will turn on to indicate
that the key has been successfully programmed.
19. Remove the programmed remote from the socket. Test the remote by pressing
Lock/Unlock.
20. Repeat steps 15 through 19 for any additional remotes. A maximum of 4 remotes
may be learned to the vehicle.
21. When all remotes have been programmed, unplug the programmer
from the OBD-2 port.