Instruction manual

5.1 Mounting of the DORO Base Unit
The DORO Base Unit is mounted to the receptacles of the OR Table. Since the distance between
the receptacles of OR Tables vary, the distance of the end brackets need to be adjusted. Inspect
all parts prior to use for any noticeable damage i.e. cracking, surface defects etc.
Note:
The adjustable end bracket allows you to easily mount the DORO Base Unit
to standard OR Tables.
5.1.1 Adjusting the DORO Base Unit to a standard OR Table
1. Remove the Hex Wrench from its storage holder on the left-
hand side of the Connecting Tube.
2. Locate the Hex Screw at the adjustable End Bracket to
adjust the width.
3. Using the Hex Wrench, loosen (do not remove) the Hex
Screw at the left End Bracket by turning the Hex Screw
counter-clockwise until the adjustable end bracket is loose.
4. Carefully slide the Adjustable End Bracket over the
connecting tube to adjust the width of the table rods
to the width of the receptacles of the OR Table.
5. Insert the two table rods into the receptacles of the OR
Table to verify that the width match and the Base Unit is
seated properly.
6. Make sure that the Hex Screw is seated properly in the slot
of the connecting tube. Using the Hex Wrench, lock the
width by turning the Hex Screw clockwise. Return the Hex
Wrench to its storage holder.
Once this adjustment is made for your OR Table, this step can be skipped in future use.
5. Mounting





↑
-12- -13-
DORO
®
Instruction Manual
DORO