Instruction manual

Open the Locking Lever to position the Base Handle
Assembly at the center of the connecting tube. Make sure that
the Transitional Member is connected to the Base Handle
Assembly, otherwise connect the Transitional Member
before closing. Close the Locking Lever to lock the position.
To adjust the Locking Lever tension see chapter 8.2.1
Important:
Never close the Locking Lever without the Transitional Member and the
Connecting Tube in place. This will damage the Base Handle Assembly.

open

close
5.1.2 Mounting the DORO Base Unit to a standard OR Table
1. Position the Base Unit at the head of the OR Table with the Base Handle
Assembly centered on the connecting tube.
2. If you need to adjust the Base Unit to the width of the receptacles of the OR Table see
chapter 5.1.1.
3. Insert the two table rods into the receptacles of the OR Table.
4. Turn the receptacle fastening screws at the OR Table until they are fully tightened.
5. Position the Base Handle Assembly at the desired position as described in chapter 5.1.1.7.
6. Ensure that all adjustable joints are tightly fastened and secured.
-12- -13-
DORO
®
Instruction Manual
DORO