Instruction manual

-28-
DORO
®
Instruction Manual
DORO
8.2.3 Replacing the Transitional Member
1. Open the Locking Lever by lifting up to release.
2. Removing: Align the Transitional Member with the slot of
the base handle assembly at an angle of 90°. Remove the
Transitional Member from the Base Handle Assembly by
pulling it slowly to the left-hand side (or to the right-hand
side). US-Version: The Transitional Member is equipped with a manual
lock lever. Turn the manual lock lever clockwise to unlock the Transitional
Member, then remove it as described above.
3. Replacing: Align the cleaned (or new) Transitional Member
with the slot of the base handle assembly at an angle of 90°
(knob should glide through slot). Insert the cleaned (or new)
Transitional Member into the receptacle of the Base Handle
Assembly until a click indicates that you have fully engaged
the Transitional Member. US-Version: After replacing the Transitio-
nal Member, turn the manual lock counter-clockwise to lock the Transiti-
onal Member in place. The Transitional Member should be locked before
using or transporting the base unit.
↑

90°
knob
slot
8.2.2 Checking the stability of the Transitional Member
Place the Base Unit on a straight surface e.g a clean table. Align the Base Handle Assembly
with the Transitional Member at an angle of 45° to this surface. Close the Locking Lever and
applypressuretotheTransitionalMemberinordertocheckit‘sstability.Theremustbeno
movement detectable. If there is movement, re-adjust as described about in 8.2.1.
Transitional Member
Base Handle Assembly
Locking Lever
↑
apply pressure
45°