English HearPlus 313ci
10 1 11 12 13 14 2 15 16 3 4 17 5 6 18 7 19 8 20 9 21 English 1. Telephone line socket 2. Handset hook 3. Keypad 4. Handset cord socket 5. Handset volume 6. Recall 7. Volume boost 8. Call memory / OK 9. Delete 10. Mains adapter socket 11. Ring tone 12. Ring melody 13. Ring volume 14. Speed dial keys 15. Phone book 16. Handset tone 17. Speaker volume 18. Speakerphone 19. UP/DOWN 20. New call indicator 21.
English Description Doro HearPlus 313ci This product can be used as a desktop or wallmounted telephone. Handset tone control, volume boost, enhanced ring volume and visual call indication make the telephone well suited for people with hearing difficulties. The extra-large keypad and easy to read display with large characters make the telephone easy to use even with impaired eyesight. The built-in phonebook can store up to 30 names and numbers.
English Installation Connection 1. Connect the curly cord to the handset and to the socket marked y on the telephone. 2. Connect the telephone line cord to a network wall socket and to the K socket on the back of the telephone. 3. Connect the mains adapter to the mains power wall socket and to the DC 9V socket on the telephone. 4. Lift the handset and listen for the dial tone. Batteries Four AA alkaline batteries are needed for the call memory and speakerphone in the event of a power cut. When BATT.
English Basic setup Before using the telephone the first time, the following basic settings should be made. After confirming a setting, the next setting is automatically displayed. To skip to the next setting, press . The phone will return to standby mode after 30 seconds of inactivity or when pressing . On first setup the display clock will show 00:00. 1. Press and hold * for about 5 seconds until the hour flashes. 2. Use v / V to change the value and confirm with . 3.
English -2- CONTRAST Use v / V to set the display contrast setting (1–4), and confirm with . KEYT. ON Use v / V to set key tone ON/OFF, and confirm with . -100- FLASH Use v / V to set the flash key time (100/300/600 ms) and ����������������� confirm with . The standard setting is 100 for most countries, 300 for France/Portugal, 600 for New Zealand. LED OFF Use v / V to enable/disable the LED indicator for new calls, and confirm with .
English Wall mounting The telephone can be wall mounted by using the included wall mount bracket and two screws (not included). Warning! Make sure that no cables, water pipes or gas pipes are located inside the wall before drilling into it. 1. Drill two holes in the wall, vertically 83 mm apart��. 2. Insert the screws, allowing them to project ~5 mm out from the wall. 3. Unplug and remove the handset. 4.
English 5. Position the telephone so that the screws on the wall fit into the slots in the bracket, then slide the telephone downwards until it is hanging on the screws. 6. Remove the handset hook (C) by pushing it upwards, and insert it in the reversed position so that the small tab (D) protrudes. The hook will now keep the handset in the cradle when the phone is wall mounted. D C C 7. Reconnect the handset and place it in the cradle.
English Operation Making a call Normal dialling 1. Lift the handset. 2. Dial the number. Hang up the handset to terminate the call. Speakerphone Note! The speakerphone only works when batteries are installed or mains adapter is connected. 1. Press s to activate the speakerphone. The LED next to the key will light up. 2. Dial the number. Press s again to terminate the call. Lift the handset to switch from speaker to handset during a call. Pre-dialling 1. Enter the number.
English Quick redial 1. Lift the handset or press s. 2. Press to redial the last dialled number. Dialling numbers in the call memory 1. Press to display the most recent call. 2. Use v / V to scroll through the last 15 incoming and outgoing calls. = Incoming call = Outgoing call 3. Lift the handset or press s to dial the displayed number. Speed dial (one-touch dialling) 1. Press one of the speed dialling keys A/B/C. The stored telephone number is displayed. 2. Lift the handset or press s to dial.
English Ring signal The ring melody and tone can be adjusted using the sliders on the bottom of the telephone. Ring melody Ring tone The ring volume is adjusted with the switch on the right side of the telephone. Volume control The speaker volume is adjusted with a slider on the right side of the telephone. The handset volume control is located under the handset.
English Additional functions Phone book The phone book can store up to 30 entries. When the memory is full, ----100% is displayed. Storing numbers in the phone book 1. Press and hold b until a blinking cursor is shown. 2. Enter a telephone number (up to 22 digits). Use v/V to move the cursor and to erase if needed.Use # to insert a pause in the number. 3. Press to confirm. A blinking cursor will be shown on the second line on the display. 4.
English Editing numbers in the phone book 1. Press b to open the phone book. 2. Use v/V to browse through the phone book, or enter the first character to quickly find an entry. 3. Press and hold b until the blinking cursor appears. 4. Use v/V to move the cursor, and use and the keypad to erase and enter new data. 5. Press to confirm. The cursor will move to the second line. 6. Repeat step 4 to edit the name/description. 7. Press to confirm. OK is displayed. Storing speed dial numbers 1.
English Deleting speed dial numbers Speed dial numbers can not be deleted, they can only be replaced by storing a new number. Caller ID and call memory Caller ID allows you to see who is calling before you answer and to see who has called in your absence. Note! The Caller ID function must be subscribed. Please contact your network operator for more information. The call memory will store the last 15 incoming and 15 outgoing calls.
English Copying call memory entries to the phone book 1. Press then v / V to scroll through the call memory. 2. Press and hold * until OK is displayed. The HearPlus to the selected number has now been saved phone book. Call timer The display shows the current time when in standby A B C mode. During a call the display will show a call timer instead, indicating the duration of the call. 2 1 after The call duration is displayed for 5 seconds the call is terminated.
English Hearing aid This telephone is hearing aid compatible. Select the T mode on your hearing aid to enable this feature. Volume Boost The handset volume can be raised another 10 dB by pressing the Volume Boost key while talking. The LED indicator on the key will light up. Press the key again or terminate the call to turn off Volume Boost. Warning! The handset volume can be very loud with this setting. Volume boost should only be used by persons with impaired hearing.
English Care and maintenance Your unit is a technically advanced product and should be treated with the greatest care. Negligence may void the warranty. • Protect the unit from moisture. Rain/snowfall, moisture and all types of liquid can contain substances that corrode the electronic circuits. If the unit gets wet, you should remove the battery and allow the unit to dry completely before you replace it. • Do not use or keep the unit in dusty, dirty environments.
English Warranty and technical data This product is guaranteed for a period of 24 months from the date of purchase. In the unlikely event of a fault occurring during this period, please contact the place of purchase. Proof of purchase is required for any service or support needed during the guarantee period. This guarantee will not apply to a fault caused by an accident or a similar incident or damage, liquid ingress, negligence, abnormal usage, nonmaintenance or any other circumstances on the user’s part.
English Version 1.
