design on speaking terms Manual pmr 510 2-way UHF personal communicator
1 2 9 8 7 6 5 3 4 1 2 3 4 5 PTT button (Push To Talk) Monitor button Search button Channel lock button Scroll buttons Indicator 6 7 8 9 Menu button On/Off button Display Headset socket Function Battery charge indicator. Automatic shutdown. Channel lock. Volume control. PS Power saving/Stand-by mode. Sending messages/talk. Incoming signals/Channel busy. Shows the selected channel/Repeater mode. SCAN Signal search.
English Setting Up Unpacking The package should include the following items: - 2 handsets with belt clips - 8 alkaline batteries - This manual - Guarantee Card Please Note! An optional Accessory Pack is available (pmr a-pack) that contains: - 2 Ni-MH rechargeable battery packs, - A twin handset charger and mains adapter, - 2 headsets, - 2 carry cases. Approved usage This product can be freely used in Australia and New Zealand without a license.
English Setting Up Belt clips A belt clip is included, which can be fitted on the back of the handset once the batteries have been installed. The belt clip allows the handset to be attached to a belt, waistband or similar. To remove, lift the small tab at the top of the clip and simultaneously push upwards. Range The communication range is dependent on many factors, with the maximum range being achieved when there are no obstacles in the transmission path (line of sight).
English Operation Channel Selection This product can operate on the available 40 channels for UHF CB use in Australia and New Zealand, refer to the channel/frequency allocation table on page 7. If the selected channel is being used by other persons an alternate channel can be selected, the channel number will be displayed in the stand-by mode. 1. Press the w button until CHAN flashes in the display. 2. Scroll to the desired channel using the v /V buttons. 3.
English Operation Communication between the handsets 1. Ensure that you use the same channel, e.g. 1. 2. Hold the handset approximately 10 cm in front of you at face height. 3. Press and hold the PTT button, wait a second and then speak clearly towards the handset. Release the button when you have finished speaking. 4. The handset is now ready to receive. 5. If nobody answers, try sending a CALL signal by pressing and holding the PTT and v buttons simultaneously. 6.
English Operation Type of CALL signal You can select different handset Call signals. 1. Press the w button repeatedly until CA flashes in the display and a signal is heard. 2. Scroll to the desired setting using the v /V buttons. 3. Press the PTT button to confirm selected signal. Automatic shutdown You can select automatic shutdown to conserve battery power. If no button is pressed within the set time period (hours) the handset will switch off.
English Other Troubleshooting The handset will not turn on - Check the batteries are installed correctly. - Ensure the batteries are in good condition and/or are fully charged. Cannot change channel or volume setting - Ensure the Channel Lock function is not active. Reduced operating range - Batteries may be failing, replace or recharge batteries if the indicator shows low. - Operating in built up areas or undulating terrain? Line of sight/flat open environment provides for maximum range.
English Other Australia and New Zealand If you believe this product is malfunctioning, please refer to the relevant section and/or consult the troubleshooting guide in this manual to ensure that you have followed the instructions carefully. As an alternative you can visit our web site for FAQ’s or send an e-mail for a prompt reply. Guarantee This product is guaranteed for a period of 12 months from the date of purchase. Should you experience difficulties with the product, please contact us for assistance.
Australia Version 1.
