Operating Instructions

7
start searching automatically and stop when a radio station is found. Release the knob once
a station has been found.
5. Repeat the above step until your desired radio station is found.
6. Adjust the volume knob to your desired volume level.
7. AM reception: the receiver has a built-in AM bar antenna. If reception is weak, slightly
rotate or reposition the unit to improve AM reception.
8. FM reception: the receiver has a built-in FM wire antenna hanging at the rear cabinet.
For best reception, completely unravel and extend this wire.
9. When you have finished listening to the radio, turn the volume knob in a counterclockwise
direction to switch the unit off. Unplug it from the power supply if you are not going to use it for
a while.
FM and FM-stereo mode
 FM mode: use the radio band selector to select the FM band. Programs are received in mono
mode. Use this mode when stereo reception is weak.
 FM-Stereo mode: use the radio band selector to select FM-ST for receiving stereo programs.
Once a stereo signal is received, the ST icon will light up on the display.
Phono Operation
1. Open the dust cover and turn the volume knob clockwise to turn the equipment on.
2. Use the function selector to select PHONO mode.
3. Set the speed selector to the appropriate position: 33, 45 or 78, depending on the record to
be played.
4. Set the auto stop control to ON if you want the turntable to top turning when it has reached
the end of the record. If the switch is set to OFF, the turntable will continue turning at the end
of the record.
5. Place the record on the turntable (use the 45 rpm adaptor, if required).