Operating Instructions

8
6. Move the lift lever towards the back to raise the tone arm from the arm park, then slowly
move the arm to the record, as illustrated on the right. The turntable will start rotating.
7. Move the lift lever towards the front, the tone arm will gently drop onto the record and
playback will start.
8. To stop playback, move the lift lever towards the back to raise the tone arm. The turntable will
still be rotating but the record will stop playing. To continue playback, move the lift lever
towards the front.
9. To play a different piece on the record, move the lift lever towards the back, move the raised tone
arm to the start of the piece and then move the lift lever towards the front to lower the tone arm
and start playback.
10. To adjust the volume level, turn the volume knob to the right or left.
11. At the end of the record, move the lift lever towards the back to raise the tone arm and move it
back to the tone arm park, and then move the lift lever towards the front to lower the arm onto its
rest.
12. Alternatively, lift the tone arm off the record and return it to the arm rest manually.
13. When you have finished playing records, engage the tone arm lock to protect it from accidental
movement. Turn the volume knob in a counterclockwise direction to switch the unit off. Unplug it
from the power supply if you are not going to use it for a while.
NOTE: Should your record stop before the last track finishes, set the auto stop control to OFF. Your
record will now play to the end, but you will have to stop the turntable rotation manually.
(Return the tone arm to its rest manually and if the turntable is still rotating, switch off the unit
by the volume control knob. Then set the auto stop control back to ON.)
Phono encoding
1. Set the function button to PHONO mode and then insert a memory device (USB drive, SD or
MMC card).
2. Put your record onto the turntable and get it ready for playback.
3. Press the record REC button. It will take about 3 - 4 seconds to read the memory device,
then the USB or SD icon will be flashing on the LC display.
4. Press the skip up
or skip down button to select the desired mode (USB or SD)
for encoding, then press the record
REC button again to confirm.
(You can skip this step if only a USB drive or an SD/MMC card is inserted.)
5. The system will start the encoding mode after a few seconds.