General Instructions

ManualsBrandsDotted Line™ ManualsCloset & Bedroom StorageDiggs 25.2 Garment Rack

GARMENT RACK DOUBLE SHELF

GENERAL INSTRUCTIONS

Thank you for purchasing this product.

Please read these instructions carefully before use.

Keep these instructions for future reference.

■

REQUIRED TOOL: NO. 2 PHILLIPS HEAD SCREWDRIVER

•

Assembly by 2 people is recommended

In order to avoid damage,

do not use an impact driver.

WARNING

* WEIGHT CAPACITY IS MEASURED VALUE, NOT GUARANTEED VALUE.

* PRODUCT SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.

PARTS

• PLEASE CONFIRM THE FOLLOWING PARTS ARE INCLUDED BEFORE ASSEMBLING.

• PACKAGING MATERIAL IS NOT MARKED. EXTRA HARDWARE INCLUDED FOR CONVENIENCE.

Long Bolts (4)

This part is already installed in

to the hanger rack pipes.

The side with the

hole is the underside

front

Upper Board (1)

underside

The side with the rounded

corners is the front

front

The side with the rounded

corners is the front

Lower Board (1)

Upper Pipes (2) Lower Pipes (2)

Hanger Rod (1)

2 holes

Rack Pipe (1)

U-Shaped Pipe (1) Felt Stickers (5)

Covering Stickers (5)

Spacers (5)

Screwdriver (1)

Screws (5)

Nuts (5)

Short Bolts (5)

Flat Screws (5)

PRECAUTIONS

FOR INDOOR STORAGE USE ONLY

FOR SAFE USAGE PLEASE OBSERVE THE FOLLOWING:

• Keep product on a ﬂat, stable surface.

• Do not use on balconies; especially in high-rise buildings.

• Do not use near stove or other sources of ﬁre.

• Please observe weight tolerance and do not overload product.

• Balance hanging objects evenly on product for even weight distribution.

• Please check that screws are properly tightened after installation. Screws may loosen over time; re-tighten as needed.

When moving products:

• Remove all items and lift evenly from both sides.

• Hold lower pipes when moving up and down steps.

For safety:

• Do not allow children to play with product.

• Do not hang on product or apply unnecessary weight.

• Pipe edges may be sharp: be careful not to cut hands

To avoid damage to product:

• Keep away from direct sunlight or high humidity.

• Wipe away any water, oil, or soap immediately.

• Do not place hot or wet items on the product.

• Do not place stickers or tape on product.

• Wipe off any excess grease from pipes

CLEANING METHOD

TO MAINTAIN HIGH PERFORMANCE OF THE PRODUCT, PLEASE MAKE SURE TO OBSERVE THE FOLLOWING:

• For hard to remove stains, wipe with diluted dish soap on damp cloth and dry thoroughly

• Do not use cleaning products such as alcohol, gasoline, bleach or detergent powder.

64cm W x 40cm D x 151.2cm H PRODUCT SIZE (cm/in)

Epoxy coated steel and ﬁnished particleboard

MATERIALS

WEIGHT CAPACITY (

kg/lbs) Hanger Rod: 10kg/22lbs Upper Board: 5kg/11lbs Lower Board: 10kg/22lbs

25.5" W x 15.75" D x 59.5" H

Summary of content (2 pages)

PAGE 1
PRECAUTIONS GARMENT RACK DOUBLE SHELF FOR SAFE USAGE PLEASE OBSERVE THE FOLLOWING: GENERAL INSTRUCTIONS FOR INDOOR STORAGE USE ONLY • Keep product on a flat, stable surface. • Do not use on balconies; especially in high-rise buildings. • Do not use near stove or other sources of fire. • Please observe weight tolerance and do not overload product. • Balance hanging objects evenly on product for even weight distribution. • Please check that screws are properly tightened after installation.
PAGE 2
ASSEMBLY METHOD 1 • RECOMMENDED TO ASSEMBLE WITH 2 PEOPLE • IF ASSEMBLING INDOORS, BE WARY OF UNEVEN SURFACES SCRATCHING THE FLOORING. • GLOVES SUGGESTED TO AVOID INJURY DURING ASSEMBLY. • ASSEMBLE NEAR LOCATION OF INTENDED USE. 2 Insert the Upper Pipes and adhere Felt Stickers to bottom of Lower Pipes. Use the diagram below as reference and be mindful of the direction the pipes are facing, with indented holes facing out of Upper Pipes and 2 holes facing back of Lower Pipes.