Owner's Manual

ASSEMBLY INSTRUCTIONS
F
I
J
F
F (4) I (8) J (4)
STEP 1
STEP 2
H (4) A (1)A (1)
Screw each LEVELER (J) into the
bottom of each BOTTOM POLE (F).
Turn clock-wise to screw in place.
Starting from the bottom of the
BOTTOM POLE (F), attach two pieces
of black plastic SLIP SLEEVES (I) on
either side of the pole in the desired
groove. Slide the plastic SLIP
SLEEVES (I) down until they click into
position. Repeat for the other three
poles.
Tip: Use the grooves on the pole as a
guide to ensure a level shelf height.
A
F
I
J
With the SMALL SHELF (A) on its side,
slide each of the BOTTOM POLES (F)
through the shelf collars.
Stand the unit upright and push down
on the SMALL SHELF (A). Using a
rubber mallet to lightly hammer the
SMALL SHELF (A) down over the
collars is helpful but not necessary.
Note: For stability, the lowest SMALL
SHELF (A) should be installed no
higher than the 3rd indentation from
the bottom of the BOTTOM POLES (F).
F
F
F
2