Owner Manual

Step 4
Page 7
å
The centers of the BRACKETS used to hang your unit are spaced 19-11/16" apart. With your tape measure, measure
the distance on your wall. Then, mark the locations on your wall with a pencil. The marks should be 3" down from the
top of your unit.
å
Next, drill the holes that are marked on the wall using a 1/4" drill bit.
å
NOTE: If attaching the Peg Board to a wall made of concrete, plaster, or other material, go to your local hardware store
for proper hardware.
å
Using your hammer, gently tap the WALL ANCHORS (4) into the holes in your wall. Then, turn two SILVER 1-1/2" PAN
HEAD SCREWS (5) into the WALL ANCHORS (4).
å
NOTE: Do not use a power screwdriver to tighten the SCREWS.
å
NOTE: Do not completely tighten the SCREWS. There should be approximately a 3/16" gap between the SCREW and
WALL ANCHOR.
å
Carefully insert the SCREWS in your wall into the large holes in the brackets on the back of your unit. Then set the unit
down into place.
å
NOTE: Please read the back pages of the instruction booklet for important safety information.
å
This completes assembly. Clean with your favorite furniture polish or a damp cloth. Wipe dry.
19-11/16"
Top of your unit
3"
The wall
SILVER 1-1/2" PAN HEAD SCREW
(2 used in this step)
5
4
5
Vertical
5 lbs. each
Pegboard
20 lbs. total