Installation Manual

21
Reflections off of the lens can be problematic in certain lighting conditions. It is
recommended that all camera components inside the enclosure are covered with black
material (i.e. foam) to minimize reflections and optimize performance. Mounting the
camera closer to the lens can also help minimize reflection issues and maximize image
quality. This can be achieved through the use of 4x #6-32 standoffs of varying lengths
depending on the application (see images from previous section for details).
4. Replace Lens Assembly
4.1. Ensure that the front O-Ring seal is still installed and completely within the seal groove. Re-
install or make adjustments as necessary.
4.2. Re-install the Front Ring, lens, and 8x #6-32 fasteners on the front of the housing. Every screw
should be started into its mating thread before tightening any of the 8 screws. Torque each of
the 8 screws to 9 in-lbs. in an alternating (i.e. star) pattern.