Installation Manual

24
5.3. Loosen the two tilt adjustment screws until there is zero clamping force from the screws. There
should be a visible gap between the screw heads and the bracket prior to adjustment. Adjust
the tilt angle to the desired position and tighten the screws to 200 in-lbs. If the housing was
removed from the mounting bracket in section 5.1, re-install the housing on the mounting
bracket during this step, making sure that the tilt angle is optimal for the install.
5.4. Run cables from the mounted unit to the desired location where data and/or power connections
can be made. This process in installation specific and may have been done prior to installing the
camera (see beginning of 3. Cable Connections). Test camera functionality and control.