Installation Manual

7
2. Camera Installation
Install camera inside BASH enclosure.
2.1. Open enclosure by unscrewing 8x #6-32 captive screws located around front ring of the
enclosure using a 7/64” hex key (commonly known as an Allen key/Allen wrench). Keep front
ring, lens, and screws together as one assembly and set aside.
It is recommended that the protective cover on the camera lens be left on until
installation is complete. This reduces the risk of scratching the lens.
2.2. Remove internal mounting plate by unscrewing 4x #6-32 screws using a 7/64” hex key. Set
aside the 4 screws and accompanying washers for later use.