User Manual


12

Installing Camera Bracket
Panasonic NS-202
1. Install the Panasonic NS-202 camera onto
the D2 Camera Bracket center hole with (1)
.25"-20 3/8" Long Bolt, and (1) .25" Lock
Washer that are included.
2. The Panasonic NS-202 camera requires a
2.5" spacing for optimal fit and operation.
Use (1) 1.5" standoff and (1) 1.0" standoff
that are provided to create a 2.5" standoff.
You will need to create 4 of these with the
included hardware.
Required components (see component
checklist): Part# 1,2,4,5,6,7,& 8
3. The 2.5" standoffs will be inserted on
the lower lens portion of the D2.
1.5"
1.0"
4. Now slide the camera bracket with the
camera into place to line up with 4 screws
from the standoffs.
5. Secure the plate by using (4) .5"
standoffs to lock the bracket in place. The
two front location will require the use of (2)
.25" washer.
This edge nests in arch at front of D2
This edge of the bracket faces back of the D2 enclosure
Picture represents standoff location & orientation.
Height of standoffs will vary depending on camera used.
Picture represents camera bracket orientation & how it is
secured. Don’t’ forget to mount your camera to the D2
camera bracket based on instructions.
