User Manual


17

Installing Camera Bracket
Sony RX550N
1. Install the Sony RX550N camera onto the
D2 Camera Bracket with (4) m3-.5 ½” long
screws, (4) m3 external lock washer, and (4)
m3 1/8" washer that are included.
Required components (see component
checklist): Part # 1,2,12,14,15, & 16
4. Now slide the camera bracket with the
camera into place to line up with 4 screws
holes from the standoffs.
5. Use (4) #8-32 screws (Phillips head) to
secure the bracket into place.
Again, make sure the camera
bracket is facing the right direction.
This edge nests in arch at front of D2
This edge of the bracket faces back of the D2 enclosure
Tip: Insert (2) #8-32 screws in the front two
standoffs to provide a guide to slide the
camera bracket into. The last two corner
holes should line up and be secured last.
3. The .5" standoffs will be inserted on the
upper portion of the D2.
2. The Sony RX550N camera requires a .5"
spacing for optimal fit and operation. Use (4)
.5" standoffs that are included.
.5"
Picture represents standoff location & orientation.
Height of standoffs will vary depending on camera used.
Picture represents camera bracket orientation & how it is
secured. Don’t’ forget to mount your camera to the D2
camera bracket based on instructions.
