User Manual


15

Installing Camera Bracket
Sony RZ30N
1. Install the Sony RZ30N camera onto the D2
Camera Bracket center hole with (1) .25"-20 3/
8" Long Bolt, (1) .25" Lock Washer, and (1) .25"
Washer that are included.
2. Use (1) m3-.5 ½” long screw in the second
corner hole to prevent the Sony RZ30N from
moving left and right. The screw will protrude
out from the bracket about ¼”. The Sony RZ30
should have a threaded hole that will align with
the second corner hole.
Required components (see component
checklist): Part # 1,2,3,6,7,8,12, & 14
3. The Sony RZ30N camera requires a
2.25" spacing for optimal fit and operation.
Use (1) 1.5" standoffs and (1) .75" standoffs
that are provided to create a 2.25" standoff.
You will need to create 4 of these with the
included hardware.
.75"
1.5"
5. Now slide the camera bracket with the
camera into place to line up with 4 screws
holes from the standoffs.
6. Use (4) #8-32 screws (Phillips head) to
secure the bracket into place.
Again, make sure the camera
bracket is facing the right direction.
This edge nests in arch at front of D2
This edge of the bracket faces back of the D2 enclosure
Tip: Insert (2) #8-32 screws in the front two
standoffs to provide a guide to slide the camera
bracket into. The last two corner holes should
line up and be secured last.
4. The 2.25" standoffs will be inserted on the
upper portion of the D2.
Picture represents standoff location & orientation.
Height of standoffs will vary depending on camera
used.
Picture represents camera bracket orientation & how it is secured.
Don’t’ forget to mount your camera to the D2 camera bracket based
on instructions.
