D2 Series Product Instructions


14

Installing Camera Bracket
Sony RZ25N
1. Install the Sony RZ25N camera onto the
D2 Camera Bracket with (3) m3-.5 ½” Long
screw (3) m3 External Lock Washer, and (3)
m3 1/8" Washer that are included.
Required components (see component
checklist): Part # 1,2,3,12,14,15,& 16
2. The Sony RZ25N camera requires a 1.25"
spacing for optimal fit and operation. Use (1) .75"
standoffs and (1) .5" standoffs that are provided to
create a 1.25" standoff. You will need to create 4
of these with the included hardware.
.5"
.75'
4. Now slide the camera bracket with the camera
into place to line up with 4 screws holes from the
standoffs.
5. Use (4) #8-32 screws (Phillips head) to secure
the bracket into place.
Again, make sure the camera
bracket is facing the right direction.
This edge nests in arch at front of D2
This edge of the bracket faces back of the D2 enclosure
Tip: Insert (2) #8-32 screws in the front two
standoffs to provide a guide to slide the camera
bracket into. The last two corner holes should
line up and be secured last.
3. The 1.25" standoffs will be inserted on the
upper portion of the D2.
Tip: Don not screw all the way through.
Screw them in enough to catch some thread
on all three screw locations. Once all three
screw catch enough thread, begin tightening
one at a time.
Picture represents camera bracket orientation & how it is secured.
Don’t’ forget to mount your camera to the D2 camera bracket
based on instructions.
Picture represents standoff location & orientation.
Height of standoffs will vary depending on camera
used.
