D2 Series Product Instructions


21

D2 Heater-Blower PCB D2 Tornado PCB
D2 Ring of Fire PCB D2 CoolDome PCB
+
l
+
l
+
-
+
_
Below are the pictures of the PCB board for the following D2 Environmental Enclosures. The picture
identifies where the 12VDC output terminals are. All D2 environmental enclosures come standard with a
12VDC Right Angle Barrel Plug (3.3mm x 5.5mm with a 1mm center pin) for majority of the IP cameras
on the market. For the Sony RZ25N and RX550N that uses terminal connectors for their power, you will
need to remove the included camera plug and replace it with the 18 AWG gauge wire lead that was
provided. Use a mini-flat head screw driver to loosen or tighten the terminals. The positive and negative
terminals are printed on the PCB.
For 12VDC IP cameras that utilizes non-standard barrel plugs without a center pin, cut approximately 18-
24 inches from the camera power supply. Use a multi-meter to determine the positive and negative leads
and attach it to the proper terminals.
*This process is only for cameras that DO NOT take a standard 12VDC
Right Angle Barrel Plug (3.3mm x 5.5mm with a 1mm center pin).
Camera Power Setup
(NON-STANDARD 12VDC CONNECTOR)
