User's Manual

Points to note:
 Original power cable is recommended. Other cables may lower the performance of sterilizer.
 Areas not exposed to the UV light will not be sterilized.
 The sterilization effect on the areas of an item can differ depending on the amount of UV radiation
exposure, distance from the light source, and other factors.
 In terms of sterilizing effect, the area of an item that is touching the bottom surface of the sterilizer
is lower than other areas.
 When the lid is opened, sterilization does not take place. Yet the adjustment of wireless charging
panel does not interfere the sterilization process.
 Place the electronic device at the charging panel with the touch screen facing up, and body
superimposing the charging coil, marked by the “flash” logo, for an optimal charging efficiency.
 Wireless charging function could be undermined when protective case is not removed from
smartphone.
 Avoid direct contact with UV lamp as exposure to it can be harmful. Prevent your eyes from
contacting with the UV light directly.
 Keep the case away from water and heat sources.
 Watch your fingers from getting pinched when closing the cover.
Warnings:
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference;
(2) This device must accept any interference received, including interference that may cause undesired
operation.
This equipment may generates radio frequency energy and may cause harmful interference to radio
communications. There is no guarantee that interference will not occur in a particular installation. If it
causes suspected interference to radio or television reception, the user is encouraged to try to correct
the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
 Consult the dealer or an experienced radio/TV technician for help.
The user is cautioned that changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance
of 15 cm surrounding the device and 20cm above the top surface of the device must be respected.
This device complies with Part 18 of the FCC Rules. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:
●Increase the separation between the equipment and any other radio device.
●Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.