P ar t N o . 9 0 - X- DS 2 63N -E UEX0 3 M ade i n K o re a USER'S MANUAL DoubleSight DS-263N LCD MONITOR For the latest updates and more information, visit our website at www.doublesight.
Contents Contents Contents.............................................................................................................. 1 Preface................................................................................................................ 2 Installation........................................................................................................... 4 Unpacking.......................................................................................................................
Preface Important Safety Instructions Important Safety Instructions Preface This manual is designed to assist users in setting up and using the LCD Monitor. Information in this document has been carefully checked for accuracy; however, no guarantee is given to the correctness of the contents. The information in this document is subject to change without notice. This document contains proprietary information protected by copyright. All rights are reserved.
Installation Installation Adjust angle of Tilt stand allation 20o Before unpacking the LCD Monitor, prepare a suitable workspace for your Monitor and computer. You need a stable and clean surface near a wall power outlet. Make sure that LCD Monitor has enough space around it for sufficient airflow. Though the LCD Monitor uses very little power, some ventilation is needed to ensure that the Monitor does not become too hot.
Display Controls Display Controls Adjusting the Monitor's Display User Controls A brief description and the location of all LCD Monitor functions controls and indicators The monitor has four function control buttons to select among functions shown on OSD menu, designed for easy user-viewing environments. OSD Function Menu To activate the OSD Main menu, simply press ”Menu” button , the menu diagram will pop up on the screen as shown on Fig.
Display Controls Display Controls Function Description Function Description Figure Function DV MODE BRIGHTNESS CONTRAST SHARPNESS Function Description The following DV mode display setting can be selected by OSD (STANDARD/TEXT/sRGB/MOVIE/GAMING/PHOTO) Default setting: TEXT Adjust the brightness. Factory setting: 100.0% Adjust the image contrast. Factory setting:50.0% Adjust the sharpness.
Display Controls Display Controls Function Description Function Description RESOLUTION NOTIFIER Factory setting: OFF Input Select DVI Information -D Provide information about resolution, H/V frequencies, and polarity of the input signal.
Display Controls Display Controls OSD Lock Out Function Function Description When the monitor is displayed for the first time and the Auto Adjust resolution is 800x600 and above, the monitor will auto (Analog Input adjust itself. Only) To manually execute the Auto Adjust function, press the Auto button. OSD Lock Function allows you to lock out the OSD menu and the button keys.
Technical Information Technical Information Power Management Specifications LCD Panel Size Di s p l ay T y p e Resolution Dis p lay Do t Display Area (mm) Display Color Mode 26" A c ti v e ma t r ix c o l o r T F T LC D 1920 x 1200 1920 x (R GB) x 1200 550.08 x 343.8 (H x V) 16.7M (RGB 8 bit) Video Input Signal Input Impedance Polarity Amplitude Multi-mode Supported Analogue RGB ; Digital TMDS 75 Ohm ± 2% (VGA) Positive, Negative (VGA) 0 - 0.7 ± 0.05 Vp (VGA) Horizontal Frequency: 31 ~ 93.
Technical Information Technical Information Standard Timing Table Standard Timing Table If the selected timing is NOT included in table below, this LCD monitor will use the most suitable available timing.
Troubleshooting Troubleshooting This LCD Monitor has pre-adjusted using factory standard VGA timings. Due to the output timing differences among various VGA cards in the market, users may initially experience an unstable or unclear display whenever a new display mode or new VGA card is selected. Attention This LCD Monitor Supports Multiple VGA Modes. Refer to the Standard Timing Table for a listing of modes supported by this LCD Monitor.
