Manualshelf

User Guide

ManualsBrandsDouglas Lighting Controls ManualsElectronicsBT-IFC-A is a commercial lighting controller that communicates with other devices in the lighting control system using Bluetooth meshing technology
12345678910
9
8. INSTALLATION
Installation Advice
• Install the BT-IFS-A in a location where direct light from the fixture does not enter the sensor
• Install the BT-IFS-A vertically with sensor facing directly to the floor or work surface below
• BT-IFC-A may be installed in non-horizontal location. Mounting location on the fixture must take into consideration line of sight
installation in the ceiling grid. Anything that prevents line of sight is likely to reduce Bluetooth range.
• Neither device may be installed in a location surrounded by metal; installation in a metallic enclosure will interfere with Bluetooth
communications
• Product must be installed in accordance with local electrical codes
Installation Steps
• Refer to Fig. 8.1
• Remove retention ring
• Push sensor through standard ½ inch electrical knockout
• Affix retention ring over device to secure in place
• Connect wires by pushing stripped conductor firmly into terminal and according the appropriate wiring diagram below
• Use #20 - #26 AWG solid copper conductors, stripped to 4 mm
Fig. 8.1: Mounting details for sensor/controller
BT-IFS-A BT-IFC-A
CAUTION
Risk of Electric Shock. All servicing should be performed by qualified service personnel. To reduce the risks of
electric shock disconnect power supplies before servicing.
!