Owner Manual

ManualsBrandsDovecove ManualsOutdoor & Patio FurnitureOutdoor Highfill Rocking Solid Wood Chair with Cushions

Assembly Instructions

Caution: You must read this before you proceed

Rocking Chair

Caution: This Chair is NOT a TOY.

Keep your child/children at bay during the assembly process.

The Chair and its parts are heavy, whenever lifting or moving them, two

adults are needed to execute these actions.

1 of 8

Summary of content (8 pages)

PAGE 1
Assembly Instructions Caution: You must read this before you proceed Rocking Chair Caution: This Chair is NOT a TOY. Keep your child/children at bay during the assembly process. The Chair and its parts are heavy, whenever lifting or moving them, two adults are needed to execute these actions.
PAGE 2
Part List Label Picture Description QTY A Backrest Panel 1 B Right Arm with Leg Panel 1 C Left Arm with Leg Panel 1 D Seat Panel 1 E Back Cushion 1 F Seat Cushion 1 Description QTY ① Allen Key 2 ② Screw (M7x70mm) 9 Hardware Label Picture 2 of 8
PAGE 3
Assembly Preparation Before Beginning Assembly: Assembly Steps Overview Back Cushion (E) Backrest Panel (A) Right Arm with Leg Panel (B) Seat Cushion (F) Left Arm with Leg Panel (C) Seat Panel (D) FRONT FACING This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Chair, the above picture is to help you put the various parts into perspective.
PAGE 4
Step 1 Unpack and place all parts on a clean, non-marring surface. Step 2 2.1) Position Seat Panel(D) between Left Arm with Leg Panel(C) and Right Arm with Leg Panel(B) as shown in above picture. 2.2) Secure Right Arm with Leg Panel(B) to Seat Panel(D) using Screws(②) with Allen Key(①). Do not fully tighten the Screws.
PAGE 5
Step 3 With assistance from your adult partner, turn the Chair over. Attach Left Arm with Leg Panel(C) to Seat Panel(D) using Screws(②) with Allen Key(①). Do not fully tighten the Screws. Step 4 Stand the Chair up. Align Backrest Panel(A) between Left Arm with Leg Panel(C) and Right Arm with Leg Panel(B) as shown in above picture. Attach Backrest Panel(A) to Left Arm with Leg Panel(C) and Right Arm with Leg Panel(B) using Screws(②) with Allen Key(①). Do not fully tighten the Screws.
PAGE 6
Step 5 Inspect it and make sure all parts are adequately connected. Gently and gracefully, sit onto the Chair. This will help to align all the parts at all joint areas. Then get off the Chair and proceed to tighten the Screws in a sequential manner. When tightening the Screws tighten sequentially. DO NOT tighten any Screw fully and then move on towards the next one. If there are still wobbles, loosen the Screws and execute this same process. Place Seat Cushion(F) and Back Cushion(E) onto the Chair.
PAGE 7
Step 6 Your Rocking Chair is ready for use. This Rocking Chair can only be used on a flat, level surface.
PAGE 8
of 8