Operation Manual

Fitting the outside air intake

duct

If the appliance is installed in a room without sufficient

ventilation, you can install the connecting kit on the

appliance for the supply of outside air.

The air supply tube has a diameter of 100 mm. If

installing a smooth tube, it may be no longer than 12

m. If accessories such as bends are used, the

maximum length (12 m) must be reduced by 1 m for

each accessory used.

Outside air intake duct through the

wall or the floor and the connection

collar

1. Make a hole in the wall or the floor (refer to

Appendix 2, "Dimensions" for a suitable position

of the hole).

2. Fit the air intake duct airtight to the wall.

3. Fit the connection collar (A) to the M6 stud (B)

using the nut (D) and the sealing ring (C); see next

figure.

Building into a new hearth

The stove is installed in two stages:

Placing and connecting the stove

Build up the fireplace around the stove.

Subject to change because of technical improvements