Technical data

Installation guideline

Preparatory measures

The replace should be hermetically connected to a well-functioning chimney, sufciently

enclosed to keep combustible materials (oor and walls) at a distance, and should be installed

in a room with sufcient ventilation.

Please inform about national or local norms and regulations concerning this subject. Your

distributor will give you the necessary advice.

You can also consult the re department and/or an insurance company about specic demands

or regulations.

Please read the technical specications under cover in this manual before installing the ap-

pliance.

The chimney

The chimney (the ue) has a double function:

It draws air, that is necessary for good combustion, into the stove.

It functions as an exhaust pipe for combustion gases via thermal or natural draught. Ther

mal draught is caused by the difference in heat between the air in- and outside the ue.

The heated air in the ue is lighter than the colder air outside the ue and consequently

rises up, along with the combustion gases. Natural draught is caused by environmental

phenomena, such as wind.

It is prohibited to connect several heaters to one chimney (for instance the central heating

boiler), unless local or national regulations allow this.

Please check which chimney is to be used for the stove you purchased and whether your

chimney is appropriate for this specic usage. You should consider an expert’s opinion on

this matter.

The chimney should meet the following conditions:

The ue should be made of reproof material. Ceramic or stainless steel is re-commen-

ded.

The chimney should be airtight and thoroughly cleaned and should guarantee a sufcient

draught (a draught or negative pressure of 15 to 20 Pa is ideal under normal circumstan

ces).

It should run as vertically as possible. Changes in direction or horizontal segments will

disrupt the smoke ow and may cause soot to cumulate inside the ue (and clog the

ue!).

The chimney’s inside dimensions must not be too large in order to prevent the smoke

from cooling off too much. For recommended chimney dimensions, see the technical

specication under cover. Larger dimensions can be used if the ue is well insulated.

•