Operating Instructions and Installation Instructions

09-20021-015

Connecting to the rear

For a connection to the rear, the position of the con-

nection collar needs to be changed. The connection

collar is attached with 2 M8 nuts (key 13). Proceed as

follows:

1. First remove the baffle plate.

2. Unscrew the nuts and remove the connection col-

lar.

Check that the sealing tape on the contact sur-

face is not damaged. Replace the sealing tape

if it is damaged.

3. Place the connection collar turned 180° with

respect to its original position; see next figure.

09-20021-016

4. Fit the connection collar with the 2 M8 nuts.

5. Replace the baffle plate.

Preparing the outside air

connection

If the appliance is installed in a room with insufficient

ventilation, you can install the outside air connecting

kit to the appliance.

The air supply tube is 100 mm in diameter. If the tube

is smooth, it may be no longer than 12 metres. If

accessories such as bends are used, the maximum

length (12 m) must be reduced by 1 m for each access-

ory used.

Outside air connection via the wall

1. Make an opening in the wall (see the appendix,

"Measurements", for the correct position of the

opening).

2. Close the air connection hermetically to the wall.

Installing and connecting

1. Position the appliance in the correct place, and

make sure it is level. The appliance is designed

with adjustable feet, which may already be moun-

ted on the appliance or be included. Use these

adjustable feet so that the appliance can be placed

perfectly level.

Subject to change because of technical improvements