User's Manual

Rev B | 6 August 2020
The antenna is intended to be held approximately 2” above the ground cover
surface (soil, mulch, gravel) and is intended to detect tags that are buried up to 4”
under the surface. The antenna should be kept parallel to ground surface to
maximize the ability to detect the RFID tags that are buried parallel to the ground
surface.
To set the antenna height, hold the unit as it would normally be used and adjust
the pole extensions until the antenna face is flush against the ground, locking the
pole extensions:
Unlock, decrease the length of a pole extension piece by 2” then re-lock: