Operator`s manual

Manual (LOCAL) Operation

5.2.4 Ethernet Options

Actual changes to the Ethernet variables referred to below will not

take effect nor be shown on the front panel until the matrix has been

powered down and back up.

See Sections 4 and 6 for more information regarding use of Ethernet to control the

matrix.

Ethernet Menu

Set/Acquire IP Address

View and/or modify the current IP Address and Acquisition

Mode, Static or Dynamic (DHCP off or on).

Set Subnet Mask

View and/or modify the current Subnet Mask.

Note: the Acquisition Mode needs to be Manually (DHCP =

OFF) for this parameter to be changed.

Set Gateway

View and/or modify the current Gateway.

Note: the Acquisition Mode needs to be Manually (DHCP =

OFF) for this parameter to be changed.

Set Port Number

View and/or modify the current Port Number. The factory

default is 10.

Set Timeout

View and/or modify the current Timeout settings (in seconds).

The factory default is 0 seconds.

The Timeout is used to automatically close the TCP/IP socket

after a certain amount of seconds of inactivity on the port.

Note: A settings of 0 seconds means that the timeout is

disabled. The TCP/IP socket will never

be closed automatically

and only one remote TCP/IP connection at the time is possible.