Installation & Assembly

ManualsBrandsDowell ManualsHome ImprovementHandcrafted Corner 30" L x 19" W Double Basin Undermount Kitchen Sink

Top-Mount / Under-Mount Sinks

INSTALLATION GUIDE

Page 1 of 4

Installation Instructions for Top-Mount / Under-Mount Sinks

Please carefully read complete instructions before beginning installation.

Note: It is recommended that all countertops be cut by an approved or certified installer and that the sinks

be installed by the installer whenever possible. The countertop/sink unit ideally should be installed as one

on the jobsite.

TOOLS AND MATERIALS YOU WILL NEED:

Eye Protection (safety glasses/goggles)

Strongly Recommended

Phillips Head Screwdriver

Ear Protection

Strongly Recommended

Tape Measure

Drill and Drill bit Pencil (NOT a permanent marker)

Saber Saw Appropriate Sealant for Countertop Material

Wood Braces Rags

Be sure to use proper tools and always wear personal safety devices for your protection.

Step 1

Place the template on the counter top in desired position and trace completely outside rim (for top-mount

installation) or inside rim (for under-mount installation) using pencil.

Step 2

Remove template and drill hole at the inside corner of the cutout line.

Summary of content (4 pages)

PAGE 1
Top-Mount / Under-Mount Sinks INSTALLATION GUIDE Installation Instructions for Top-Mount / Under-Mount Sinks Please carefully read complete instructions before beginning installation. Note: It is recommended that all countertops be cut by an approved or certified installer and that the sinks be installed by the installer whenever possible. The countertop/sink unit ideally should be installed as one on the jobsite.
PAGE 2
Top-Mount / Under-Mount Sinks INSTALLATION GUIDE Step 3 Using a saber saw, start cutting from the drilled hole along the cutout line. Support cutout until the cut is completed. Step 4 Set the sink temporarily into the cutout opening to verify fit (Left is top-mount installation and right is under-mount installation). The sink rim must set uniformly on the counter top.
PAGE 3
Top-Mount / Under-Mount Sinks INSTALLATION GUIDE Step 6 Attach and space the clips around the underside of the sink. Number of clips varies between models. Be sure to arrange spacing evenly around the sink. Apply sealant around the sink rim to serve as a watertight seal. Step 7 Lower the sink into the hole carefully and tighten the clips evenly with the screwdriver. (Left is top-mount installation and right is under-mount installation) Step 8 Wipe away the excess sealant and allow to dry.
PAGE 4
Top-Mount / Under-Mount Sinks INSTALLATION GUIDE Care and Cleaning Cleaning    Clean regularly with a mild detergent solution and/or clean water applied with a soft cloth or sponge. Rub gently. Rinse and wipe the sink dry after every use to prevent water spotting &mineral deposits in severe hard water conditions. Deep clean once a week with a recommended cleanser (be sure to rub in the direction of the finish lines) and a soft cloth or sponge rather than aggressively cleaning.